Hi, Would like to ask if the torque bar will remains at 33x for normal and 360nm even after mapped? For Boost I do know the max is 1.4bar eventhough car is map above than 1.4bar boost. What about the torque? Dyno run shows more than 400nm but torque bar doesn't shows that. Is this what everyone experiencing?
I think it's normal, because it's set to the original values! it will only show up to the maximum of the graph.
It is possible to edit the values, but it's unlikely to change the image of the power chart. See my thread on retrofitting the RS Monitor https://rsmegane.com/threads/rs-monitor-2-0-retro-install.17795/#post-186574
