Anti pollution check fuel injection system issues

Discussion in 'Electrical & Interior - Security, ICE, Wiring Loom' started by Craigcwt, Mar 10, 2021.

  1. Hi all
    Recently purchased a Megan 250
    Did not have the opportunity to get an extended drive.
    Just got round to using it this week.
    Started it up and getting both
    Anti pollution and check injection system runs lumpy on tick over..
    Any thoughts or ideas
    I have researched the issues and comes up with a few different results.
    I have a basic scanner so will look at that tomorrow
    Thanks all in advance
     
  2. ianplymouth

    ianplymouth RSM Club Member

    Would say its plugs, coil pack or crankshaft position sensor
    Also make sure you O2 sensors are plugged in properly
    Is the rpm on tick over lower or higher than normal ???
     
  3. Tick over is just lumpy is the best way I can describe it
     
  4. New battery as the previous one was in correct
    Found a sensor on the inlet cable tied
    Now instead of the Xmas tree lights on the dash...just getting anti pollution light staying on
    Any further help guys
     

  • Share This Page