/ Register

265 Torque settings

Discussion in 'Suspension, Brakes, Wheels & Tyres section' started by Friggerpants, May 14, 2020.

  1. May 14, 2020 #1
    Friggerpants

    Friggerpants

    Morning all, I'm looking at replacing wheel bearing hub and wishbones.........How much torque is required to tighten up:


    E14 bolts that hold the wheel hub to the hub carrier

    Wishbone ball joint to the hub carrier

    Wishbone to subframe

    Thanks!
     
  3. May 14, 2020 #2
    bobsan

    bobsan

     

    Attached Files:

  4. May 14, 2020 #3
    ianplymouth

    ianplymouth

    Thanks Bobsan :sunglasses:
     
  5. May 14, 2020 #4
    manugtt

    manugtt

    Driveshaft nut 280 Nm.??:fearscream::fearscream:
    I normaly fix they with the impact gun in the max. position:sweatsmile:
     
  6. May 14, 2020 #5
    ianplymouth

    ianplymouth

    FT or two grunts and a grone normally is enough :laughing::laughing:
     
  7. May 14, 2020 #6
    Friggerpants

    Friggerpants

    Perfect thanks very much!!!
     
  8. May 14, 2020 #7
    Friggerpants

    Friggerpants

    If you don’t say “that’s not going anywhere” after tightening, it’ll come loose!
     
    ianplymouth likes this.
  9. Jul 31, 2020 #8
    Friggerpants

    Friggerpants

    Has anyone got the torque settings for the rear end? Specifically the beam to chassis bolts, shock to beam bolts and caliper to carrier bolts?
     
  10. Jul 31, 2020 #9
    Danny Danger

    Danny Danger

    The beam to chassis bolts are 105nm
    upper shock bolt is 62nm
    lower shock nut is 105nm
    slide pins bolts 35nm
     
  11. Jul 31, 2020 #10
    Friggerpants

    Friggerpants

    Amazing thanks very much. Appreciate this!

    105nm is 10 urga durgas
     
  12. Aug 1, 2020 #11
    Paddy80

    Paddy80

    Brake caliper bolt, 102 or 170?
     

    • Share This Page


    • Welcome to our site! Please take a moment and Register today!