/ Register

Driveshaft Spacer

Discussion in 'Suspension, Brakes, Wheels & Tyres section' started by 250Keiran, Apr 1, 2020.

  1. Apr 1, 2020 #1
    250Keiran

    250Keiran

    Does anyone know where I would be able to get a driveshaft spacer? KTEC are currently out of office for a while so that’s a no go. Thanks
     
  3. Apr 1, 2020 #2
    bobsan

    bobsan

    do you actually need one.....
     
  4. Apr 1, 2020 #3
    ianplymouth

    ianplymouth RSM Club Member

    ^^^^ how low are you going ?????
     
  5. Apr 1, 2020 #4
    bobsan

    bobsan

    Dachshund lo or just Corgi lo ??
     
    ianplymouth likes this.
  6. Apr 4, 2020 #5
    250Keiran

    250Keiran

    Well I’ve already broke 1 driveshaft just want to prevent it happening again
     
  7. Apr 4, 2020 #6
    bobsan

    bobsan

    Would be very interesting know how this happened
     
  8. Apr 4, 2020 #7
    ianplymouth

    ianplymouth RSM Club Member

    How much have you lowered yours by then
     
  9. Apr 4, 2020 #8
    250Keiran

    250Keiran

    At a guess maybe 60-70mm?
     
  10. Apr 4, 2020 #9
    250Keiran

    250Keiran

    Not actually sure just put my foot down around a corner, hit a little bump and the cv join snapped.
     
  11. Apr 4, 2020 #10
    ianplymouth

    ianplymouth RSM Club Member

    Why ???

    Thats an awful lot :openmouth:
     
  12. Apr 4, 2020 #11
    250Keiran

    250Keiran

    I’m not entirely sure it was just a guess, it’s not super low but there’s just about no arch gap.
     
  13. Apr 4, 2020 #12
    ianplymouth

    ianplymouth RSM Club Member

    Probably not the best angle, but this is mine

    [​IMG]
     
    Jukidam likes this.
  14. Apr 4, 2020 #13
    250Keiran

    250Keiran

    I’d probably say it’s roughly the same or a little lower. Is that on coilovers yes?
     
  15. Apr 5, 2020 #14
    Danny Danger

    Danny Danger

    Measure from the floor to the wheel arch then we know how low it is
     
  16. Apr 5, 2020 #15
    ianplymouth

    ianplymouth RSM Club Member

    Yes its on BC coilovers, i didn't fit them or set them up, this was all done by CGR for track use
     
  17. Apr 9, 2020 #16
    sergio

    sergio

    It has been said several times that this does not solve anything. Even I made one myself and tried it. The problem is in the lower control arm.
     

    • Share This Page


    • Welcome to our site! Please take a moment and Register today!