Bucket seats

Discussion in 'Wanted' started by jayp250rs, Oct 6, 2015.

  1. As above nice pair of cobra or something similar
     
  2. ??
     
  3. getting a nice set of buckets second hand don't come up too often ... I scanned ebay for ages util i found my pair of Cobra Revolutions .. and I had to drive across the country to pick them up lol
     
  4. ianplymouth

    ianplymouth RSM Club Member

  5. Look like a bargain , few more the same on eBay
     
  6. ianplymouth

    ianplymouth RSM Club Member

    I am really pleased with them Steve, they are not FIA stamped, but i don't need that, they are comfy and i can get me fat arse in umm :rolleyes:

    And they turned up in a couple of days, free post so no driving around the country :wink:
     
  7. I think their actually quite comfy even after driving to Belgium I still felt good in them, plus the seats are an absolute bargain.
     
  8. Ian, what was the total cost of the seats and mounts?
     
  9. ianplymouth

    ianplymouth RSM Club Member

    All in £300
     
  10. What subframes have you gone for
     
  11. Cheap seats, look okay too
     
  12. NJH

    NJH

    They look a lot like pole positions. They make some really nice seats but its hard to understand how the same company can knock out a pair of seats including side mounts and runners for less than the price of one FIA seat. Still though I have em bookmarked just in case I go this route with mine.
     
  13. ianplymouth

    ianplymouth RSM Club Member

    Not got that far yet, i might make something up :wink:
     
  14. I run these seats with ktec mounts and are spot on,took me a while to get my driving position right. Me and the wife did over 2k miles around France in August for our honeymoon and was bearable. (Even running Bc coilovers)
    Spot on for money and a lot more supportive than the standard trendlines.
     
  15. Look like a bargain to me, see you on the 21st at Caldwell Steve
     
  16. Yep looking forward to it Steve.
     

  17. How tall are you Steve? Do the harness slots go above your shoulders on these?
     
  18. Or measure from base to the loop holes and compare to yours
     
  19. I'm only a short arse mate,I'm probably 5'9/5'10 and Iv got the narrow ones which fit me a treat. Yea the harness holes sit just above my shoulders.
     

  • Share This Page